Next, carve a 1/8 inch channel across the small segment of the L-shaped wood by using a chisel. Sand it up smoothly to avoid splinter cuts. This little L-shaped piece of wood will be the trigger for your crossbow. Now cut the L-shape out of the wood using a saw. The horizontal side of the āLā must be slightly smaller than the box you carved in the stock of the crossbow for the trigger system. Take a thin piece of pinewood and draw an L-shape on it with a pencil. Compared to metal, wood is less malleable but can easily be carved into a required shape, which can be difficult with metal sheets. Wood is an alternative to the metallic trigger approach. Finally, screw the M3 nuts, and perform testing of the trigger to ensure it works fine. Place all the other screws on the cover plate and ensure everything is in its place including the lock parts. Next, take the aluminum plate (it should not be too thin to bend easily), drill two holes of equal size, one for holding the tension spring and other for mounting, and two other holes for the stopper screws. An acrylic-based marker would work best for marking out an aluminum surface. You can design it yourself, or use existing and proven designs from various contributors over the internet. Print the design of baseplates and other two parts on a white paper, and cut it out using a scissor. You can also use wood instead of aluminum it depends on the strength of your crossbow. The tools needed for making a crossbow trigger are:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |